3-10-6. Connection of the optional output connector
(1) Connect the optional output connector (No.1) to the I/F board connector.
Note If not connected this connector, the oil discharging function does not work.
3-10-7. Fixing of the cables
(1) Attach the two of tie holders (No.1) with wood screws (No.2) which enclosed in accessory box. There
are wood screw prepared holes for the tie holders (No.1) on the rear surface of the table.
(2) Insert the cord tie (No.3) to the tie holder (No.1) and fix the cables as shown in the below figure. At this
time, please make any allowance for the machine side cables so as not to pull the cables when tilting
the sewing machine.
<1>: Tie holder <2>: Wood screw <3>: Cord tie
<1>
- 13 -
<1>: Optional output connector
<3>
<1>
<2>