Table of Contents
Advertisement
3-10. Connection of the electric cables
(1) Please make sure to ground the place where there is a
shock and/or malfunction.
Connect the machine head and the control box with cables as following below instruction.
Connect each connector fully to ensure sufficient contact.
CON F Power supply
(Connect to power switch box)
CON G Operation panel
CON Ｍ Main servo encoder
CON J I/F board signal
(Connect to I/F board (MIF)）
CON P XY axis encoder
CON Q PF axis encoder
CON L Foot switch
CAUTION
mark. Failure to do so may cause electric
- 8 -
CON A I/F board power
(Connect to I/F board (MIF))
CON H general purpose port
(Connect to PC）
CON B Main servo motor
(Connect to spindle servo motor)
CON K universal serial
communication port
CON D XY axis stepping motor
(Connect to sewing machine head
stepping motor)
CON E PF axis stepping motor
(Connect to sewing machine head
PF axis stepping motor)
Advertisement
Table of Contents
