Installation; About This Chapter; Connect Me906S To Board - Huawei ME906s LTE M.2 Hardware Manual

Table of Contents

HUAWEI ME906s LTE M.2 Module

Hardware Guide

This chapter describes the assembly of ME906s, including:



Figure 7-1 Install the module

It refers to M.2 specification.

The module will need a mechanical retention at the end of the board. The module

specifies a 5.5 mm Dia. keep out zone at the end for attaching a screw.

The module Stand-off and mounting screw also serve as part of the module Electrical

Ground path. The Stand-off should be connected directly to the ground plane on the

platform. So that when the module is mounted and the mounting screw is screwed on

to hold the module in place, this will make the electrical ground connection from the

module to the platform ground plane.

The module could not be installed or removed when the host is powered on.

Otherwise, it may result in permanent damage to the module.

Issue 05 (2019-03-25)

Connect ME906s to board

Thermal Management

Antenna Plug

Huawei Proprietary and Confidential

HUAWEI M.2 Module

Installation

Table of Contents