Tunable Antenna Control - Huawei ME906s LTE M.2 Hardware Manual

HUAWEI ME906s LTE M.2 Module
Hardware Guide
Figure 3-22 Circuit of the USIM card interface
 The ESD protection component should choose low capacitance. The capacitance
of the component should be lower than 10 pF.
 To meet the requirements of 3GPP TS 51.010-1 protocols and electromagnetic
compatibility (EMC) authentication, the USIM socket should be placed near the
M.2 interface (it is recommended that the PCB circuit connects the M.2 interface
and the USIM socket does not exceed 100 mm), because a long circuit may lead
to wave distortion, thus affecting signal quality.
 It is recommended that you wrap the area adjacent to the USIM_CLK and
USIM_DATA signal wires with ground. The Ground pin of the USIM socket and the
Ground pin of the USIM card must be well connected to the power Ground pin
supplying power to the ME906s module.
 A 100 nF capacitor (0402 package is recommended so that greater capacitance
such as 1 uF can be employed if necessary) and a 33 pF capacitor are placed
between the USIM_PWR and Ground pins in parallel. Three 33 pF capacitors are
placed between the USIM_DATA and Ground pins, the USIM_RESET and Ground
pins, and the USIM_CLK and Ground pins in parallel to filter interference from RF
signals.
 It is recommended to take electrostatic discharge (ESD) protection measures near
the USIM card socket. Transient voltage suppressor diode should be placed as
close as possible to the USIM socket, and the Ground pin of the ESD protection
component is well connected to the power Ground pin that supplies power to the
ME906s module.
3.7

Tunable Antenna Control

The module provides 4 tunable antenna control pins.
Issue 05 (2019-03-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description of the Application Interfaces
38