Page 5
Explanatory text is also given for more complicated steps. In the event of any problems with the instructions or the accessory, contact your local Volvo dealer. Note! Some steps in these installation instructions are presented with illustration only.
Page 7
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Remove the screw at the lower edge of the boot lid's upper panel. Perform on both sides. IMG-303067 Illustrations A and B Detach the panel's lower, outer and inner ends from the lower panel, and pull it from the clip at the sides.
Page 8
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Detach the boot lid's upper panel at the upper edge by using a weatherstrip tool until the clips release. Place the panel to one side. IMG-302790 Remove the panel for the boot lid's lock.
Page 10
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to cars with electric boot lid opener Illustrations A and B Carefully pry off the connector from the panel using a weatherstrip tool. Unplug the connector from the contact and place to one side.
Page 11
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to all models Illustrations A and B Remove the lower panel by first prying loose the four clips at the bottom. Then pull the panel off carefully, insert a pair of flat-nosed pliers, press the locking pin's hooks together and pull the locking pin out.
Page 13
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Illustration A Carefully pry off the handle from the boot lid using a weatherstrip tool. It is secured by twelve catches. Illustration B Disconnect the connector and place the handle to one side. New handle can be found in the kit.
Page 14
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Remove the upper part of the side panel. IMG-303068 Slacken off the two screws that hold the boot lid's sill at the crossmember a few turns. Carefully pull off the trunk lid's sill panel. The panel is secured by six clips.
Page 15
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Remove the seat cushion by pushing in the sprung lock (1) underneath and then pulling upward (2). Repeat the operation on the other side. IMG-328943 Applies to cars with electrically heated seat cushions Disconnect the connectors by the sides at the rear edge of the seat cushion.
Page 16
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden IMG-268017 Fold the left-hand backrest forward. Remove the side cushion on the left by first pulling it backwards at the upper edge until the hooks (1) release. Then pull it inwards slightly until the hook (2) releases, and upwards until the locating pin (3) disengages from the mounting at the rear edge.
Page 18
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Remove the C-pillar panel by carefully pulling it out at the lower edge so that the two retaining clips release. Pull it out at the upper edge until the last clip releases.
Page 19
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Illustrations A and B Remove the left-hand side panel by grasping it at the upper edge and carefully pulling it from the car body. Lift up the panel and pull it to one side. The panel is secured by six clips.
Page 20
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Take the cable harness marked A from the kit and insert the cable in the large hole in the panel and out through the hole where the handle was. IMG-330068 Pull the cable harness through the right-hand hole in the boot lid.
Page 21
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Illustrations A, B and C Insert the connector with camera into the hole on the right side of the boot lid. Connect the connector on the left-hand side and press the handle into place.
Page 22
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Illustrations A and B Tighten the handle with existing screws. IMG-303172 IMG-303173 Route the cable along the existing cable to the heating elements in the rear window towards the right-hand side of the boot lid.
Page 23
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Drill two Ø 6.5 mm (17/64 ") holes for clamping the cable at the upper edge of the boot lid, in the positions illustrated. Remove any swarf. IMG-303175 Press two cable ties with clips into the drilled holes.
Page 24
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Carefully pry off the left-hand side of the rubber grommet so that the catches release. Unhook the rubber grommet from the boot lid. Carry out the same with the end that is in the body.
Page 25
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Clamp the cable at the hole edge using a cable tie with edge clips. IMG-303265 Insert the piece of wire through the boot lid's rubber grommet. Tape the connector and a piece of the cable at the wire.
Page 26
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Insert the cable through the hole in the body. IMG-303267 Illustrations A and B Take the receptacle housing with catch for the camera cable's contact from the kit. Press the receptacle housing onto the connector until a click is heard.
Page 27
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Reinstall the rubber grommet in the body and boot lid. IMG-303283 Illustrations A and B Route the cable harness to the left towards the D pillar. Route at the D pillar along the existing cable harness to the rear edge of the fuse holder.
Page 29
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Carefully bend off the covers in the driver seat's rear attachments with a weatherstrip tool. Remove the screws. Move back the seat slightly to expose the front floor mat at the trailing edge.
Page 30
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Remove the tunnel console's panel. It is fastened with seven clips on the inside. IMG-298585 Carefully pry loose the panel with air blower all round. The panel is secured by five clips on the sides and at the top and with four mounting springs on the lower edge.
Page 31
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Pull out the panel and disconnect the connector for the hazard warning lights. IMG-282524 Illustrations A and B Insert a small screwdriver in the gap on the media player. Press in the inner catch and carefully pry off the surround on one side using a weatherstrip tool.
Page 34
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Remove the tunnel console's right-hand side panel by carefully pulling it away starting at the front edge. The side panel is secured with five clips on the inside. IMG-282528 Fold the floor mat to one side by the left-hand side of the tunnel console.
Page 35
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Loosen the clips on the cable harness from the tunnel console. Disconnect the connectors for the CCM. IMG-282543 Loosen the connector to the keypad for CCD, if the car is equipped with this.
Page 37
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to all models IMG-282545 Illustrations A and B Carefully pry off the centre console's panel starting at both sides at the rear edge. It is secured by two clips along the long sides and four hooks around the gear lever's panel.
Page 41
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Remove the two screws at the bottom of the centre console's lower panel. IMG-303809 Carefully pry at one end of the mounting bracket so that the entire centre console moves backwards a few centimetres until the bracket engages the air ducts on both sides.
Page 42
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Position a small sleeve between both brackets so the centre console does not move back. IMG-303811 For all cars with display Carefully pull the panel backwards so that the screws for the display can be accessed.
Page 44
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden In cases where a connector is connected to the designated position, loosen the connector, fold back the cable and secure the connector to the existing cable harness. Use: Electrical tape. IMG-352251 Applies to all models...
Page 45
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to left-hand drive cars Illustrations A and B Note! Check that the correct connector is positioned under the seat respectively tunnel console. Routing cable harness B Take cable harness B from the kit and route it into the mat joint under the left-hand seat towards the tunnel console and in front of the mat.
Page 46
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to all cars that do not have a pre-mounted display. Routing cable harness C Take cable harness C from the kit. The shorter ground lead has a lot of excess that can be hidden under the mat by the left-hand seat.
Page 47
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Routing the ground cable in cable harness C, continued route the ground lead the same way as cable harness A towards the rear crossmember. Press the B pillar panel into place again.
Page 48
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Clean the marked surfaces on the of the rear crossmember and floor using isopropanol and wipe dry. IMG-303863 Secure the cable using wide pieces of silver or woven tape along the rear crossmember and to the floor.
Page 49
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Connect the ground lead's ring cable terminal to the ground terminal closest to the spare wheel well. Tighten the ground screw. Tighten to 10 Nm (7.5 lbf.ft.). IMG-303867 Cut off the cable terminal on the short ground lead in cable harness C.
Page 50
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Illustration A Splicing the ground lead in cable harness C Splicing with insulated damp-sealed crimping sleeve Colour Cable area, mm² Stripping length mm Green/White 0.3 - 0.5 0.5 - 1.0 Blue 1.0 - 2.5 Yellow 4.0 - 6.0...
Page 51
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Pressing the sleeve Illustration A Insert the crimping sleeve in the press tool P/N 9512785. Select the socket as per colour coding. Clamp the pliers together slightly, but only so that the crimping sleeve remains in the pliers.
Page 52
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Heating the crimping sleeve Illustrations A and B Place a suitable shield behind the cables to be crimped to prevent thermal stress to the surrounding area. Warm the sleeve with a hot air gun, P/N 9512777, and suitable nozzle.
Page 53
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to all cars that do not have a pre-mounted display. Pry up the catch on the green connector. IMG-329263 Take special tool, part no. 9512637 and carefully press into the hole above the cable terminal in position 1 to release the catch.
Page 54
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Carefully push the new cable terminal on the newly spliced ground lead into Pos 1 in the connector. Press the connector's catch securely into place. IMG-329265 Insulate and tape the excess cable terminal at the connector's cable harness.
Page 57
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Collect the cables and clamp them using the cable tie in the bracket. Note! Ensure that the cables are correctly positioned and bent at the connectors. If necessary, insert any excess inside the floor mat.
Page 59
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden 102A Applies to left-hand drive cars Illustrations A and B Routing cable harness B/cable harness C Insert the wire into the centre console, up towards the compartment above the air outlet and out through the hole on the right-hand side in the compartment where the display is to be positioned.
Page 60
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden 103A Applies to right-hand drive cars Routing cable harness B/cable harness C Insert the wire into the centre console, up towards the compartment above the air outlet and out through the hole on the left-hand side in the compartment where the display is to be positioned.
Page 61
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Connect the connector on the routed cable to display. IMG-352252 Applies to all where the display is included in the kit. Carefully pull the panel back so that the new display can be installed.
Page 63
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to all models Reinstall the display. Take screws from the kit or use existing screws and tighten the display. Note! Do not damage the display and panel. IMG-303887 Move the panel back into place and ensure that the locating pins enter their holes.
Page 68
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden 119A Illustrations A and B Take the panel with CCM and insert the cables in the tunnel console. Place it at the upper edge and secure it with clips at the rear edge.
Page 70
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to cars that do not have a pre-mounted display. Connect the connector (1) that was disconnected from the tunnel console's left-hand side to the corresponding connector (2) in the routed adapter cable.
Page 73
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden 129A Applies to cars that do not have a pre-mounted display. Illustrations A and B Replacement of the panel for the air vent Poke the catches downwards using a small screwdriver. Fold down the air nozzle and unhook it from the four mounting eyelets at the lower edge of the panel.
Page 75
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to all models Connect the hazard warning light connector. IMG-282568 Secure the panel. Make sure that all air nozzles align correctly in the air ducts in the dashboard and that all clips and catches engage.
Page 83
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Install new clips in the lower panel. Pull the cables for the lighting and contact for the door opener out through the hole in the panel. If the car is equipped with a KV antenna, connect its connector.
Page 85
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Check that all clips are intact and properly positioned. Replace any broken clips. Reinstall the upper panel by first pressing the upper edge and then the sides at the same time as aligning the lower panel.
Need help?
Do you have a question about the 30756314 and is the answer not in the manual?
Questions and answers