Honda Dream DX CD110 Owner's Manual page 58

7. Remove the "Drive Chain" (11) from
the driven sprocket by pushing the rear
wheel forward.
8. Remove the "Rear Axle Shaft" (12), side
collar and rear wheel from the swing
arm.
(10)
(12)
(10) Sleeve Nut
(11) Drive Chain
(12) Rear Axle Shaft
Installation Notes
To install the rear wheel, reverse the
removal procedure.
54
CD110 Dream DX
• Tighten the rear axle nut, sleeve nut
and brake stopper arm nut to specified
torque.
Rear axle nut torque:
54 N.m (5.5 kgf.m, 40 lbf.ft)
Sleeve nut torque:
44 N.m (4.5 kgf.m, 32 lbf.ft)
(11)
Brake stopper arm nut torque:
22 N.m (2.2 kgf.m, 16 lbf.ft)
● Adjust the brake (page 13) and drive
chain (page 48).
● After installing the wheel, apply the
brake several times and then check if
the wheel rotates freely. Recheck the
wheel if the brake drags or if the wheel
does not rotate freely.
● Always replace used cotter pins with
new ones.
If a torque wrench was not used for
installation, see your Honda dealer as
soon as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Honda Motorcycle & Scooter India Pvt. Ltd.