Advertisement
Table of Contents
Assembly Instructions
Step 5
Two Person Assembly Recommended
Connect wall panel zip to the roof
and base zips (under Velcro flaps).
Lock poles into connecters
by rotating left or right
Insert pole into connector
(ensure poles are fully inserted)
NOTE
Rotate locking
mechanism until it clicks
Insert pole into connector
(ensure poles are fully inserted)
If unable to Insert pole
Equipment Hangers
Upper Equipment Hanger
Lower Equipment Hanger
Step 6
Parts List
Zip the wall panel to the roof and base.
Yellow Pole
Green Pole
Straight
3-Way
Red Pole
x12
x28
Connector
Corner
x33
x14
x8
3-Way
4-Way
5-Way
Equipment
Support Pole
T Piece
Join
Join
Hanger Ends
Foot
x14
x4
x2
x24
x2
Advertisement
Table of Contents
Related Manuals for Mammoth Tents Elite 360S
Summary of Contents for Mammoth Tents Elite 360S
- Page 1 Assembly Instructions Step 5 Two Person Assembly Recommended Connect wall panel zip to the roof and base zips (under Velcro flaps). Lock poles into connecters by rotating left or right Insert pole into connector (ensure poles are fully inserted) NOTE Rotate locking mechanism until it clicks Insert pole into connector...
- Page 2 Step 1 Step 3 Insert ceiling poles into 3-way corners, 3-way T pieces, 4-way joins and 5-way joins. Lay out base ensuring Velcro flap is in front right corner. Fit equipment hanger ends to poles. Position equipment hangers as required. Assemble floor poles, 3-way corners and 3-way T pieces as shown.
Need help?
Do you have a question about the Elite 360S and is the answer not in the manual?
Questions and answers