Mammoth Tents Elite 360S Assembly Instructions page 2

Step 1
Lay out base ensuring Velcro flap is in front right corner.
Assemble floor poles, 3-way corners and 3-way T pieces as shown.
3-Way T Piece
Step 2
Insert lower wall poles into 3-way corners and 3-way T pieces.
Fit straight connectors.
Insert upper wall poles into straight connectors.
Fit 3-way corners, 3-way T pieces and 4-way joins on top.
4-Way Join
Straight Connector
3-Way Corner
Velcro Flap
3-Way T Piece
3-Way Corner
Step 3
Insert ceiling poles into 3-way corners, 3-way T pieces, 4-way joins and 5-way joins.
Fit equipment hanger ends to poles. Position equipment hangers as required.
Fit support poles into 5-way joins at the top and support pole feet at the bottom.
5-Way Join
Support Pole
Foot
Step 4
Fit roof ensuring Velcro
flap is in front right corner.
3-Way T Piece
Equipment
Hanger End
Velcro Flap