Advertisement
Step 5
Connect wall panel zip to the roof
and base zips (under Velcro flaps).
Step 6
Zip the wall panel to the roof and base.
Assembly Instructions
Two Person Assembly Recommended
Lock poles into connecters
by rotating left or right
Insert pole into connector
(ensure poles are fully inserted)
Equipment Hangers
Lower Equipment Hanger
Parts List
Yellow Pole
Green Pole
x12
x44
4-Way
5-Way
Join
Join
x2
x1
NOTE
Rotate locking
mechanism until it clicks
Insert pole into connector
(ensure poles are fully inserted)
If unable to Insert pole
Upper Equipment Hanger
Straight
3-Way
3-Way
Connector
Corner
T Piece
x11
x8
x12
Equipment
Support Pole
Hanger Ends
Foot
x16
x1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Mammoth Tents EliteHC 240
Summary of Contents for Mammoth Tents EliteHC 240
-
Page 1: Assembly Instructions
Assembly Instructions Step 5 Two Person Assembly Recommended Connect wall panel zip to the roof and base zips (under Velcro flaps). Lock poles into connecters by rotating left or right Insert pole into connector (ensure poles are fully inserted) NOTE Rotate locking mechanism until it clicks Insert pole into connector... - Page 2 Step 1 Step 3 Insert ceiling poles into 3-way corners, 3-way T pieces, 4-way joins and 5-way join. Lay out base ensuring Velcro flap is in front right corner. Fit equipment hanger ends to poles. Position equipment hangers as required. Assemble floor poles, 3-way corners and 3-way T pieces as shown.
Need help?
Do you have a question about the EliteHC 240 and is the answer not in the manual?
Questions and answers