Tieline Genie Distribution User Manual page 265

Click Next Stream to configure the first audio stream with default algorithm, jitter and
FEC settings which are physically entered in the codec. Alternatively, click Next to
specify individual algorithm, jitter buffer and FEC settings (recommended) and more
connection endpoints.
Click the drop-down arrows on the right-hand side of each text box to adjust the
Encoding
Click to configure:
© Tieline Research Pty. Ltd. 2020
Important Note: The Remote Audio Port is the codec port at the remote end
of the link to which you are sending audio. The Local Audio Port is used by
the local codec to receive audio from the remote codec. When Tieline Codecs
is the Session Protocol selected (using Tieline session data), the default port
value for the Local Audio Port is Automatic. Note: Automatic indicates that
the codec will arbitrarily allocate the local port value and send this information
to the codec to which you are dialing. Click to deselect the Automatic check-
box and change this setting.
, or
Sample rate
· Auto Jitter Adapt and the preferred auto jitter setting using the drop-down arrow for
Buffer priority. It is also possible to configure the Minimum depth and Maximum
depth of jitter over the connection. See
· Alternatively, select a Fixed Buffer Level and enter the Jitter Depth, which must
be between 12ms and 5000ms depending on the algorithm you select.
Genie Distribution WNET Manual v3
options.
Bit rate
Configuring the Jitter Buffer
265
for more details.