Tieline Genie Distribution User Manual page 162

162 Genie Distribution WNET Manual v3
3. Click Save when configuration is complete to store the new Config settings.
4. This configuration will associate an incoming call to this B channel with a corresponding
Answer Route configured in the answering program, e.g. Answer Route 1 in the following
image.
More detailed information about how to configure the codec to answer and route multiple
sessionless ISDN calls is available in
uses examples to explain how to set up consistent deterministic routing of multiple incoming
sessionless calls.
Answering both Tieline Session and Sessionless ISDN Calls
Leave the Sessionless Only check-box in the ISDN Answering Config unchecked if the codec is
expected to receive ISDN calls from Tieline codecs, or both Tieline and non-Tieline codecs (i.e. you
are not sure which type of codec may call). In this mode, when the codec answers a call it initially
expects to receive Tieline session data from the dialing codec and configure its own algorithm
settings according to that. If it fails to receive Tieline session data within 5 seconds (i.e. a non-
Tieline codec is calling, or a Tieline codec with session data disabled), it will use the settings in the
ISDN Answering Config instead.
The following image displays how the answering codec will behave in this mode when receiving calls
from both Tieline and non-Tieline codecs.
Using ISDN Answer Routes for Sessionless ISDN Calls. This
© Tieline Research Pty. Ltd. 2020