Using The Ice Cream Maker - ALDI Ambiano User Manual

Using the ice cream maker

PLEASE NOTE!
Risk of damage!
If the freezer bowl is fi lled before the appliance is switched on, the
paddle can become jammed. There is a risk of damaging the mo-
tor. Please follow the safety advice below:
− Always switch on the appliance fi rst and only use the chute to
fi ll the appliance while it is running.
1. Pack the freezer bowl
2. Place the freezer bowl upright in the freezer compartment.
At a temperature of -18° C the cooling process takes around 12 hours. If the tempera-
ture in the freezer is higher, the cooling process can take up to 24 hours.
The double-walled freezer bowl contains coolant. Put the freezer bowl
back into the freezer if you can hear liquid moving around when you move
the bowl. If you do not hear anything, the freezer bowl is suffi ciently
pre-chilled.
3. Mix the ingredients for the desired type of ice cream according to the recipe (see
Chapter "Recipe suggestions" on page 14) in a seperate bowl and place the
mixture in the refrigerator for about 4 hours.
4. Place the base
chilling process. (Fig. E)
5. Mount the motor unit
pins 4 catch in both recesses in the cover and the motor unit locks into place
audibly.
6. If the motor unit does not lock into place by itself, press the release button
and lock the motor unit into place.
7. Fit the paddle
8. Put the cover
release buttons
(Fig. F)
9. Only connect the appliance to a properly installed earthed power point that
complies with electrical safety requirements. The local mains voltage must corre-
spond to the technical specifi cations for the device.
The display 2 shows an operation time of 20 minutes.
9
into a suffi ciently large freezer bag.
10
on an even surface, and insert the freezer bowl after the
3 in the recess on the cover
8 onto the shaft. (Fig. F)
5
with the motor unit onto the freezer bowl. Ensure that the
7 fi t into the recesses properly and click into place audibly.
Using the ice cream maker
5 , ensuring that both
1
13