Installing A Hard Drive - Transcend STOREJET 2.5 IDE User Manual

Installing a Hard Drive

If you purchased a StoreJet
installed, please read this section, otherwise you can skip to the
1.
Open the StoreJet
the diagram.
2.
Remove the cover revealing a control board adapter; this converts the IDE interface connector of the
hard drive to a Mini USB 2.0 interface.
3.
It is IMPORTANT! to properly line up and then plug in the IDE connector pins on the hard drive to the
adapter sockets. Do NOT force the pins into their sockets and do NOT insert the hard disk at an angle;
otherwise, you may damage the IDE connector pins. If a pin on the hard drive gets bent, do not panic;
simply straighten the pin gently using a pair of tweezers.
Installing a Hard Drive
™
2.5 (TS0GSJ25R/S/B) that does not have a Hard Disk Drive already
™
2.5 by removing the two screws from either side of the top cover, as indicated in
Figure 2. Remove the screws from the top cover
Figure 3. Remove the top cover revealing the IDE adapter
Figure 4. Connect the hard drive to the IDE adapter
"Driver Installation" section.
6