Installing A Hard Drive - Transcend TS120GSJ25T User Manual

Installing a Hard Drive

If you purchased a StoreJet
section, otherwise you can skip to the
1.
Open the StoreJet
the diagram.
2.
Remove the cover revealing a control board adapter; this converts the IDE/SATA interface connector
of the hard drive to a Mini USB 2.0 interface. Slide out the control board.
3.
Carefully line up and plug in the IDE/SATA connector on the control board to the hard drive. Do NOT
force the IDE/SATA connector into the hard drive and do NOT insert the connector at an angle,
otherwise you may damage it.
Installing a Hard Drive
™
2.5 that does not have a Hard Disk Drive already installed, please read this
"Driver
™
2.5 by removing the two screws from either side of the top cover, as indicated in
Figure 2. Remove the screws from the top cover
Figure 3. Remove the top cover revealing the IDE/SATA adapter
Figure 4. Connect the hard drive to the IDE/SATA adapter
Installation" section.
6