For Your Safety - Bernina Mega User Manual

Application
Preparation
The BERNINA embroidery hoop Mega in the size of 40.0 cm x 15.0 cm allows comfortable
embroidering of very large embroidery motifs and prevents the material from being re-hooped.
Depending on your embroidery machine, the motifs need to be embroidered in three areas. The
hoop will be moved to the respective embroidery area. As the embroidery machine is able to
join the embroidery section exactly together, neither misalignements nor gaps in the embroidery
motif will occur.
The embroidery hoop is accompanied with embroidery templates where the embroidery area is
marked in 1cm squares. Various punch wholes are helpful to transfer markings or corner points
onto the material.

For your safety

› Make sure that you read the instruction manuals of the embroidery machine as well as of this
accessory carefully before use!
Calibrating the embroidery hoop
The embroidery hoop calibration involves the coordination of the needle and the center of the
hoop. The calibration can only be carried out when the embroidery module is connected.
According to the machine type, following steps need to be performed.
B 880, B 830, B 780 und B 750 QE
› attach the desired embroidery hoop
› insert the appropriate embroidery template
› select «Calibrating the hoop» in the Setup program
› select the attached hoop
› follow the instructions shown on the Display
Any other BERNINA embroidery machines
› attach the embroidery hoop Oval
› insert the embroidery template
› select «Calibrating the hoop» in the Setup program
› follow the instructions shown on the Display
The calibrations for the embroidery hoop Oval correspond with all hoop sizes.
Selecting embroidery template
› Select the embroidery template in accordance with your embroidery machine.
5