Keypad And Implementing; Description Of Display Indication; Startnumber And Stn-Automatic; Adjustments In Subprogram Speed - ALGE-Timing Timy SPEED Manual

1

Keypad and implementing

Please see Timy manual „GENERAL" .
2

Description of display indication

Description of settings:
Startnumber and startnumber-automatic
Measured speed
Adjusted distance
Speed unity
Measuring-direction
If the start-photocell is triggered out, the display will show instead of "0.00" a dotted line.
Timy will calculate from the adjusted distance and min. speed, how long one cycle will take at
maximum. If this time will be crossed, the display will show "0.00" and is ready for the next
measurement.
2.1

Startnumber and STN-automatic

Here you can adjust the requested start number. You should always confirm it with one of the
"OK" buttons. You can use the same startnumber for several times.
The startnumber-automatic can be adjusted at "Main menue", "General", "STN-automatic".
Arrow upward means that the startnumber will increase for one number.
Arrow downward means that the startnumber will decrease for one number.
If no arrow is visible then the automatic is deactivated.
2.2

Adjustments in subprogram SPEED

Here you can adjust and change several setting which will also be indicated at the display
Push the button
„SPEED". You can make adjustments at the following points:
distance
direction
unity
min. speed
max. speed
print times
Timy SPEED
. Push the buttons or as long as you will see menue point
Seite 3