Colebrook Bosson Saunders AV/VC One Installation Instructions

Full front panel

anel

ndle with care

W A R N I N G

AV S - 0 2 1 - PA N 1 - I N S T - A - M AY 2 0 1 6

Installation Instructions for

AV/VC One Full Front Panel

AV S / 0 2 1 / PA N 1

REFER ALSO TO MAIN

INSTRUCTIONS FOR AV/VC

ONE STAND INSTALLATION

E L E C T R I C A L S A F E T Y

•

Safe installation of electrical equipment is the responsibility of the installer.

•

Colebrook Bosson Saunders recommends that only double-insulated

electrical equipment and cables are installed in AV/VC One unit.

M A I N T E N A N C E A N D I N S P E C T I O N

•

Ensure all screws and fixings are fully tightened and occasionally re-tighten if necessary.

•

Clean with a dampcloth. DO NOT use solvents.

D I S C L A I M E R

As part of Colebrook Bosson Saunders ongoing product improvement

programme, the design of products may change without prior notice and

details may vary from those illustrated.

Table of Contents

Need help?

Do you have a question about the AV/VC One and is the answer not in the manual?

Page 1 Colebrook Bosson Saunders recommends that only double-insulated electrical equipment and cables are installed in AV/VC One unit. M A I N T E N A N C E A N D I N S P E C T I O N •...
Page 2 Install front panel to column 1 . 1 1 . 2 1 . 3 I M P O R TA N T N O T E Ensure mount hooks are fully engaged I N S T A L L A T I O N I S N O W C O M P L E T E P L E A S E C O N S I D E R L E A V I N g T h E S E I N S T R U C T I O N S w I T h T h E U N I T I F F U R T h E R I N S T A L L A T I O N M A Y b E R E q U I R E D b Y O T h E R S...