Table of Contents
Advertisement
Maintenance
To get the best performance of the System, keep your discs
and mechanism clean.
Handling Discs
• Remove the disc from its case by holding it at the edge
while pressing the center hole lightly.
• Do not touch the shiny surface of the disc, or bend the
disc.
• Put the disc back in its case after use to prevent warping.
• Be careful not to scratch the surface of the disc when
placing it back in its case.
• Avoid exposure to direct sunlight, extreme temperature,
and moisture.
To clean the disc:
Wipe the disc with a soft cloth in a straight line from center
to edge.
Cleaning the System
• Stains should be wiped off with a soft cloth. If the System
is heavily stained, wipe it with a cloth soaked in
water-diluted neutral detergent and wrung well, then
wipe clean with a dry cloth.
• Since the System may deteriorate in quality, become
damaged or get its paint peeled off, be careful about the
following:
– DO NOT wipe it with a hard cloth.
– DO NOT wipe it forcefully.
– DO NOT wipe it with thinner or benzine.
– DO NOT apply any volatile substance such as
insecticides to it.
– DO NOT allow any rubber or plastic to remain in
contact for a long time.
Troubleshooting
General
Adjustments or settings are suddenly canceled before you
finish.
] There is a time limit. Repeat the procedure again.
Operations are disabled.
] The built-in microprocessor may malfunction due to
external electrical interference. Unplug the power cord
and then plug it back in.
Unable to operate the System from the remote control.
] The path between the remote control and the remote
sensor on the System is blocked.
] The batteries are exhausted.
No sound is heard.
] Speaker connections are incorrect or loose.
No picture is displayed on the TV screen, the picture is
blurred, or the picture is divided into two parts.
] The video cord connections are incorrect or loose.
] The System is connected to a TV which does not
support progressive video input.
] Incorrect scanning mode is selected (see page 13).
] When you unplug the power cord and plug it back
again, the scanning mode may change back to the initial
setting (see pages 13).
The left and right edges of the picture are missing on the
screen.
] Select "4:3 LB" for "TV TYPE" (see page 32).
The picture is distorted.
] A device, such as a VCR or an HDD/DVD recorder, is
connected between the main unit and the TV. Connect
the main unit directly to the TV (see page 6).
The screen size is improper.
] The monitor type setting is not appropriate. Select the
monitor type suitable for your TV (see page 32).
] The screen size setting of the TV is improper.
The TV screen is dark.
] The screen saver setting is activated. Press any button
(see page 32).
Continued on the next page
38
Advertisement
Table of Contents
