Viewing Optical Transceivers - TP-Link TL-SG3109 User Manual

14.3 Viewing Optical Transceivers

The Optical Transceivers Page allows network managers to perform tests on fiber-optic cables.
Note:
Optical transceiver diagnostics can be performed only when the link is present.
To test cables:
Click System > Maintenance > Diagnostics > Optical Transceivers. The Optical Transceivers Page opens:

Figure 131: Optical Transceivers Page
The Optical Transceivers Page contains the following
fields:
Port — Displays the port IP address on which the

cable is tested.
Temperature — Displays the temperature (

which the cable is operating.
Voltage — Displays the voltage at which the cable is operating.

Current — Displays the current at which the cable is operating.

Output Power — Indicates the rate at which the output power is transmitted.

Input Power — Indicates the rate at which the input power is transmitted.

Transmitter Fault — Indicates if a fault occurred during transmission.

Loss of Signal — Indicates if a signal loss occurred in the cable.

Data Ready — Indicates the transceiver has achieved power up and data is ready.

o
C) at