Routine Sprayer Operation - Graco LINE X LX2000 Instructions And Parts List

13. To install the cover:
a. Lay the abrasion
assembled heated hose (H) end to end.
Refer to Figure 14.
b. With the gun disconnected from the gun
manifold (J)
disconnected from the gun, pull a couple
of inches of the cover (G) over the
manifold and hoses and tape the cover to
the hoses.
c. Push the cover (G) onto the hoses. See
Figure 14. The cover will double over
itself and be turned inside out as it slides
over the hoses.
d. Secure the other end of the cover (G) with
tape.
Figure 14
14. Install hose abrasion
spraying. The abrasion cover protects the
heated hose from damage caused by rough
surfaces. It also minimizes heat loss and
protects the couplings from damage.
part no. 070-411 and specify the total length of
your hose times 1.25.
13 684-027
cover (G) and
and the air hose
cover before
Order

Routine Sprayer Operation

CAUTION
The heater and sprayer must be primed before
turning on the heater to reduce the risk of
equipment damage.
Refer to "First Time Startup" on pages 10 through
12 for priming procedure.
NOTE: The first time you operate the sprayer,
follow these instructions carefully.
you become familiar with this equipment, you
will learn how to quickly adjust the fluid
pressure and fluid temperature to obtain the
best results for your spray application.
1. Open the main air supply valve (1).
2. Open the main air supply valve and the air
valves (8) to the feed pumps (3).
Typical Installation on page 5.
3. Adjust the air
proportioning pump motor to 50 PSI (3 bar).
4. Slowly open the air valve (214) to the
proportioning pump.
5. Start the heaters. See Figure 15.
WARNING
Never operate the heater with the ATC sensor
cord unplugged from the heater junction box. If
unplugged, the heater will overheat which can
cause overpressurization and rupture and result
in serious bodily injury.
a. Turn all three ATC temperature range
selectors (72, 77) to OFF.
b. Set all three Temp Set dials (73) to
115°F (46°C).
c. Turn the circuit breakers (63) to "I" for
ON.
d. Let the material heat for 15 minutes.
e. Set the heated hose ATC (77) to MED.
NOTE: Graco recommends always using the
hose ATC even if the heater ATC is not used.
Then, as
See the
regulator (212) to the