Schwinn 810 Assembly Manual / Owner's Manual page 44

Condition/Problem
Thumping sound when
belt operates
Walking belt not aligned
Motor sounds strained
Hesitation or walking belt
slips when in use
Belt stops moving while
in use
Console continuously dis-
plays a different program
every 1.5 seconds
44
Things to Check
Walking belt
Machine leveling
Walking belt tension and
alignment
Silicone lubrication on
walking belt
Belt tension
Safety key
Motor overload
Console is in demonstra-
tion mode
Walking belt needs to be used for wear in period. Sound will go
away after the wear in period.
Make sure the machine is level. Refer to the procedure for
leveling the machine in this manual.
Make sure the walking belt is centered and tension is correct.
Refer to the procedures for adjusting tension and aligning the
belt in this manual.
Apply silicone to the inner surface of the walking belt. Refer to
the belt lubrication procedure in this manual.
Adjust the belt tension at the rear of the machine. Refer to the
procedure for adjusting belt tension in this manual.
Plug Safety Key into Console. (See Emergency Stop Proce-
dure in the Important Safety Instructions section.)
Unit may be overloaded and draw too much current, which
causes power to turn off to protect motor. Refer to maintenance
schedule for belt lubrication. Make sure the walking belt tension
is correct, and start unit again.
If the above steps do not resolve the problem, contact Cus-
tomer Service (if inside US/Canada) or your local distributor (if
outside US/Canada).
Push and hold down the PAUSE/STOP and OK buttons for 3
seconds.
Solution