Installation - Graco 24G621 Instructions - Parts Manual

Installation

Installation Installation
The agitator speed controller fits the following Graco
pneumatic rotary motors:
Motor Motor Part Motor Part No. Part No. No.
101140
16A871
101388
111310
NOTE: NOTE: Before installing, ensure that the agitator NOTE:
air motor has at least 5 in. (12.7 cm) of vertical
clearance and 4 in. (10.2 cm) of horizontal clearance
in all directions around it.
NOTE: If you are using an air line lubricator, install it
NOTE: NOTE:
in the air line upstream of the speed controller.
1. Remove the air motor top cap (A) and needle
valve (B) using the multi-function wrench (26).
Store these parts in a safe place; they will be
needed if the speed controller is ever removed.
3A1315E
TI17254a -1
TI17255a -1
2. Install the push-to-connect air tube connector
(21) in place of the needle valve.
3. Screw the compression nut (24) onto the flange
connector (23) finger-tight. Place the connector
assembly (23, 24) onto the exposed shaft of the
air motor, flange connector side down.
Installation
TI17256a -1
TI17257a -1
3