Page 1
Instructions-Parts 24G621 Agitator Agitator Speed Speed Controller Controller 24G621 24G621 Agitator Speed Controller Accessory Accessory Accessory 3A1315E Accessory kit kit kit to to to control control and and automatically automatically maintain maintain the the speed speed of of of an...
Installation Installation Installation Installation 2. Install the push-to-connect air tube connector (21) in place of the needle valve. The agitator speed controller fits the following Graco pneumatic rotary motors: Motor Motor Part Motor Part No. Part 101140 16A871 101388 111310...
Page 4
Installation 4. Using the allen wrench (25) and multi-function 6. Connect the air tubing (27) between the speed wrench (26), tighten the compression nut (24) controller tube connector (29) and the air motor onto the flange connector at least 1/8 turn past tube connector (21).
Operation Operation Operation Operation Connect the main air line to the quick disconnect fitting (28) on the agitator speed controller. Do not exceed the maximum air inlet pressure of 100 psi (0.7 MPa, 7.0 bar). Turn knob counte rclockwis e Turn knob clockwis e to incre a s e s pe e d.
Troubleshooting Troubleshooting Troubleshooting Troubleshooting Problem Solution Problem Problem Solution Solution The speed controller does not adjust for a change in Remove the needle (13). and liberally lubricate the load, or shuts off before the knob (16) is turned all the needle and o-ring (33) with multi-purpose lithium based way down.
Repair Repair Repair Repair 11. Turn the adjustment knob (16) all the way counterclockwise (outward). Screw the adjustment nut (15) fully onto the upper housing (2). NOTE: To repair the agitator, see your separate NOTE: NOTE: agitator manual. 12. Connect the air tubing (27) between the speed controller tube connector (29) and the air motor NOTE: NOTE:...
24G621 Kit Parts 24G621 Kit Kit Parts Parts 24G621 24G621 Parts Ref. Ref. Ref. Part Part Part Description Description Description 16G418 WRENCH, multi-function Series Series Series B B B The kit contains all necessary parts and tools to 054123 TUBE, nylon; 1/4 in. (6 mm) install the agitator speed controller.
Technical Data Technical Data Data Technical Technical Data Maximum air supply pressure 100 psi (0.7 MPa, 7 bar) Minimum air supply pressure 70 psi (0.5 MPa, 4.9 bar) Maximum speed 1000 rpm Maximum speed controller air temperature 130°F (55°C) Main air inlet size 1/8 npt quick-disconnect fitting Speed control range 100–1000 rpm...
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective. This warranty applies only when the equipment is installed, operated and maintained in accordance with Graco’s written recommendations.