Incorrect Keycard; Displaying The Radio Pass Data; Short Additional Memory (S.a.m.); Turn On Message (T.o.m.) - Blaupunkt SAN FRANCISCO RDM 169 Operating Instructions Manual

KeyCard theft protection system
A maximum of two cards can be used with
the set.
If you attempt "train" a third one, the access
authorisation for the KeyCard not used for
the "training" process will be deleted auto-
matically.

Incorrect KeyCard

If a wrong KeyCard is inserted, then "Wrong
KC" will appear in the display.
Remove the wrong card and insert the cor-
rect KeyCard.

Displaying the radio pass data

You can use the KeyCard supplied with your
set to display the radio pass data such as
the model name, product number (7 6..) and
serial number.
Please refer to the section on "DSC pro-
gramming - KC (KeyCard), READ".
Short Additional Memory
(S.A.M.)
The second KeyCard available from your
specialised dealer allows you to read out
short information under the DSC menu item
"KC, READ". This information will run
through the display and could include, for
example, the phone number of your car re-
pair service or the emergency call number
of your automobile association.
The freely selectable text with a maximum
of 162 characters can be programmed by
any dealer who has the required equipment
available.

Turn On Message (T.O.M.)

The second KeyCard available from your
specialised dealer also allows you to dis-
play a special turn-on message each time
the radio is switched on.
The freely selectable text with a maximum
of 48 characters can be programmed by any
dealer who has the required equipment
available.
Each time you turn on your system with the
second KeyCard, the programmed text will
appear in the display. Important: "TOM on"
must be selected in the DSC menu.
To find out how to do this, refer to the sec-
tion on "DSC programming - KC (KeyCard),
TOM".

Flashing light as theft protection

Flashing light diode A
When the vehicle is stationary and the Key-
Card has been removed, the light diode can
be switched to flash as an extra anti-theft
device.
For this to function properly, it is necessary
that the positive power supply line and the
permanent +12 V lead are connected such
as described in the installation instructions.
Make sure that the unit is switched off; the
operating panel is unlocked; the KeyCard
has been removed; "LED ON" has been se-
lected in the DSC mode (default setting).
If necessary, please refer to the section on
"DSC programming - KC (KeyCard) LED".
Switching off the flashing light
The flashing light can be switched off by
selecting "LED OFF" in the DSC menu.

Care of your KeyCard

To ensure that the KeyCard will function
properly it is important that the contacts are
free from any foreign particles. Avoid direct
skin contact.
If necessary, clean the KeyCard contacts
using a cotton swab soaked in rubbing al-
cohol.

Lost or damaged KeyCard

If the KeyCard for your unit is lost or dam-
aged you can train a new KeyCard.
You can purchase the new KeyCard from
any authorised dealer. You will also require
61