Table of Contents
Advertisement
Assembly of the 1 x 1 m search frame
1.
Connect the pipes (8 pieces) in numerical order. Please note, that the numbers should
be readable on the upper side.
2.
Arrange the search frame on a flat surface and be sure, that the frame is straight.
3.
Afterwards the cable has to be placed on the pipe and fixed at the corners with the
provided tape. Please make sure, that cable and search frame are firmly connected to
each other.
Note: Turn off the metal detector in case you want to change the searchcoil, then connect
the selected searchcoil. Please press the Reset-button after you have started the detector
again.
11. Rechargeable battery and charger
Through the mobile Li-Ion quick-charger the
metal detector is fully charged within a very
short time (approx. 90 minutes). Thanks to
the
connection
possibility
cigarette lighter, this is also possible on the
road.. The charged battery allows an
operating time of approx. 4-8 hours.
An additional inverter module can be used
to charge the battery in the car.
KTS-Electronic GmbH & Co. KG – PULSE AR III
at
the
car
11
Advertisement
Table of Contents
