Worx WG284E Manual page 11

VIBRATION INFORMATION
Vibration total values (triax vector sum)
determined according to EN 60745:
Vibration emission value: a
Uncertainty K = 1.5m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORY
Battery pack (WA3551)
Charger (WA3876)
Blade sheath
Safety guard
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
Hedge trimmer
< 1.5 m/s²
h
WG284E WG284E.9
2 /
1 /
1
1
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended use
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
WARNING! Do not use the product
without attaching the guard and front
handle.
ASSEMBLY & OPERATION
ACTION
BEFORE USING YOUR CORDLESS
HEDGETRIMMER
Assembling the safety guard
Assembling the front handle
NOTE : The handle is designed to
prevent being assembled in wrong
direction . If you find it cannot be
installed, please turn it around.
Checking the battery charge condition
NOTE : Fig. C only applies for the
battery pack with battery indicator light.
Charging the battery pack
NOTE :
• The batteries are shipped uncharged.
Each battery must be fully charged
before the first use.
• Always fully charge the two batteries
at same time. More details can be
found in charger's manual.
Installing and Removing the battery
pack
NOTE :
• This machine will only run
when 2 batteries are installed.
It is recommended to use the
same two batteries and charge
the two batteries at the same
time.
• Using two different sized
batteries or if one battery isn't
fully charged then the machine
will only run to the lowest
common denominator.
OPERATION
FIGURE
See Fig. A
See Fig.
B1, B2
See Fig. C
11
See Fig. D
See Fig. E
EN