Komatsu PC360LCi-11 Operation & Maintenance Manual page 289

SETTING
METHOD FOR CALCULATING AUTOMATIC CALIBRATION AND WRITING PA-
RAMETER VALUE (TILT BUCKET)
1.
Tap the "Next" button.
Automatic calibration is executed.
After the calculation is finished, the screen changes.
2.
Hold down the "Set" button for 0.5 seconds or longer.
The tilt bucket parameter obtained by automatic calibration
calculation is written in Komatsu controller, and the display
returns to the menu screen.
If the bucket weight changes largely, bucket weight setting
should be executed.
For bucket weight setting, see "BUCKET WEIGHT SET-
TING".
3.
After the setting is completed, turn the starting switch key
to OFF position, turn it to ON position again, and restart
the control box.
4.
Tap the "Next" button.
If automatic calibration calculation fails, error screen is dis-
played.
In this case, the numeric value which has been input may
be wrong.
Tap the "Back" button, and check back the input result.
Tap the RETURN button and the display returns to menu
screen. At that time, the value which has been input and
measured will be reset.
CONTROL BOX
Press "Next" to calibrate the bucket's
dimensions.
7-173