IKUSI ONE Compact Configuration And Setting Manual page 9

Configuration and Setting guide ONE Compact
• Edit a channel
Press on the channel that has been configured and it may be edited.
NOTE
A specific aerial input will block part of the band when a channel is added. In the following example, a
BIII channel is blocked on the UHF band. In other words, users may only select from channels 21 to 69
on the UHF 1 input and another channel will not be able to be added that is not involved in the UHF 1
band.
If the user wants to receive another band channel, another input may be used to add the specific
channel:
• UHF1: 474-858 MHz (CH21-69) FULL band
• UHF2: 474-770 MHz (CH21-58) 4G filter
• UHF3: 474-690 MHz (CH21-48) 5G filter
To prevent signal overlap, the output channel cannot be duplicated. The application will not let this happen,
preventing a duplicated channel from being programmed in the output.
Pre-Amp On/Off: It turns the pre-amplifier that is on each RF input on or off.
Pre-amplifier power: It turns the 12V power on for a mast amplifier.
FM Pre-Amp: It turns the FM stage on or off.
ONE Compact_v1.1.7
9