Installation Requirements; Tools And Parts - Jenn-Air JGCP430 Installation Instructions Manual

IMPORTANT: Do not install a ventilation system that blows air downward toward this gas cooking appliance. This type of
ventilation system may cause ignition and combustion problems with this gas cooking appliance resulting in personal injury or
unintended operation.
In the State of Massachusetts, the following installation instructions apply:
■
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gas fitter qualified or licensed by
the State of Massachusetts.
■
Acceptable Shut-off Devices: Gas Cocks and Ball Valves installed for use shall be listed.
■ A flexible gas connector, when used, must not exceed 4 feet (121.9 cm).
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Tools Needed
Adjustable wrench
Pipe wrench
Wrench or channel lock pliers
For Propane/Natural Gas Conversions
Adjustable wrench
7 mm nut driver

INSTALLATION REQUIREMENTS

Tools and Parts

Tape measure
Flat-blade screwdriver
Pipe-joint compound
resistant to Propane gas
Drive ratchet
Masking tape
Marker or pencil
15/16" (24 mm) combination wrench
Noncorrosive leak-detection solution
1/2" (13 mm) deep-well socket
3