Craftsman 154.37837 Operator's Manual page 9

Attaching Grass Catcher
Follow steps below to attach the grass catcher:
a. Lift rear discharge door (Figure 5).
b. Remove the mulch plug (Figure 5).
c. Place grass catcher into the slots in the handle brackets (Figure 5). Let go of
discharge door so that it rests on the grass catcher.
To remove grass catcher, lift rear discharge door on the mower. Lift grass catcher up
and off the slots in the handle brackets. Release rear discharge door to allow it to
close rear opening of mower.
Rear Discharge
Your mower is shipped as a mulcher. To convert to rear discharge, make sure the
grass catcher is off, the mulching plug removed, and the mulching cover is closed
(Figure 5 and Figure 7).
1. Slightly lift the rear discharge door.
2. Lift the rear discharge handle to extend it on the back side of the discharge door
(Figure 6).
3. Lower the rear discharge door.
Attaching Side Discharge Cover
Your mower is shipped as a mulcher. To convert to side discharge, make sure the
grass catcher is off of the unit and the rear discharge door is closed.
1. On the side of the mower, lift the mulching cover (Figure 7).
2. Slide two hooks of side discharge cover under hinge pin on mulching cover
assembly (Figure 7). Lower mulching cover. Do not remove side mulching cover
at any time, even when you are not mulching.
ASSEMBLY
c
Side Mulching Cover
Side Discharge
Cover
9
a
b
c
Figure 5
Figure 6
1
2
Figure 7