Inserting Input Modules; Attaching Cables - Triax TDX User Manual

Input Modules
Inserting input
modules

Attaching cables

Signal cables can be attached when all input modules have been
installed.
1. Route the cables either through the cable openings on the top
or on the sides of the headend.
2. Attach the signal cables to the „IN‟ connector on the input
module.
1. Prize the protective cover away from
an available input slot.
2. Retain the protective cover.
Note:
Any available input slot can be used.
3. Push the input module into the input
slot until the input module is locked in
position.
4. Note details for the input module on
the label (optional).
5. Note details for the input module on
the label located inside of the door
(optional).
6. Continue inserting all additional input
modules.
16