Multi Headend Installation - Fiber Optic; Resetting Ip Address - Triax TDX User Manual

Headend Installation
Multi headend installation – Fiber optic
Resetting IP
address
Fiber-optic cables must be used to connect the main headend unit to one
or two subunits over distances greater than 100m.
The following SFP fibre-optic transceivers must be used in the Link
sockets:
Triax Art. Type
492087 Fiber (850nm) (LC)
492088 Fiber (1310nm) (LC 1000Mbps 2km
The IP address of a headend unit can be returned to the factory default
address by using the ID switch.
1. Turn off the power to the main unit.
2. Set the ID switch on the main unit to "7".
3. Turn on the power.
The four LEDs flash red and yellow until the process of resetting the IP
address has been completed.
The LEDs show green-constant if the reset process was successful.
1. Turn off the power to the main unit.
2. Set the ID switch on the main unit back to the initial setting.
3. Turn on the power to the main unit.
The IP address has been reset to the factory default.
Data rate
1000Mbps 550m
14
Reach Application
Gigabit Ethernet
Gigabit Ethernet