Removing A Slide - 3D Histech Pannoramic DESK User Manual

Pannoramic DESK 1.18.1 User's Guide

5.3.3 Removing a slide

If a slide got jammed or has suffered breakage during the process of digitization, stop the process
and, if possible, move the slide holder to a position where the slide can be easily removed.
Crush hazard! Before you remove a jammed slide, cancel the running
digitization process, terminate the software session and turn the power
off.
Any manipulation performed on a mechanical component must be followed by a complete device
initialization routine (software restart).
1. Exit control software.
2. Switch off power supply and disconnect power cable.
3. Remove the cover (see section 5.3.1 Removing the protective cover ).
4. Throw fixing lever (3) frontward to the left.
5. Remove the slide (1) from the holder (2).
May 29, 2014 - Rev. 1
Warning!
Figure 49 – Removing a slide
3DHISTECH Ltd.
5 Troubleshooting and Maintenance
70(77)