Contents Of The Cutter Kit; Tools Required; Step 1: Preparing The Printer - Datamax M-class Mark II Manual
Cutter option
Hide thumbs
Also See for M-class Mark II:
- Operator's manual (100 pages) ,
- Maintenance manual (94 pages) ,
- Manual (10 pages)
Table of Contents
Advertisement
Contents of the Cutter Kit
This kit contains the following item:
Cutter Assembly
Follow the steps listed below to install this option.
Tools Required
To install this option you will need a #2 Philips screwdriver.
Step 1: Preparing the Printer
For your safety and to avoid damaging the equipment, turn 'Off' and unplug the printer before
installing the Cutter.
CAUTION
Turn 'Off' the power switch and unplug the
printer.
Open the cover. Remove any installed media
from the printer.
Remove the Fascia by gently pulling it
forward.
Loosen and remove the Thumbscrew, then
remove the Tear Plate (or if equipped, the
Present Sensor option).
Fascia
1
Thumbscrew
Tear Plate
Advertisement
Table of Contents
Need help?
Do you have a question about the M-class Mark II and is the answer not in the manual?
Questions and answers