Working Instructions - Festool DWC 18-2500 Original Instructions Manual

English
The current setting can be read off the pre­
setting display [10-2]
Once the setting is made, drive in a test screw,
then, if necessary, correct the depth setting us­
ing the adjusting wheel [10-1]. Each setting ad­
justment shifts the stop by ± 0.1 mm.
We recommend screwdriving in the
automatic mode – see section
10
10-3
Removing collated screws
► Remove the collated screws by pulling up­
wards once (figure [11]
the transport lever at the same time as
pulling the collated screws downwards (fig­
ure [11]
).
14
10.1 b).
10-1
10-2
) or by engaging
11

11 Working instructions

– The magazine attachment must not be held
in the area of the depth stop.
– Each screwdriving process must be com­
pleted in full. Interrupting a screwdriving
process or applying pressure when screw­
driving can cause the tool to malfunction.
– The collated screws must only be changed
when the tool is at a standstill.
– The magazine attachment must under no
circumstances be used in any way other
than that described in this operating man­
ual.
– Use only original screwdriver bits.
– Use only original collated screws.
– The collated screws must always be kept in
their original packing.
– Always work at right angles to the board
that is being affixed.
11.1 Magazine attachment maintenance
The magazine attachment is essentially mainte­
nance-free. After an extensive period of use,
however, it is recommended to clean it with
compressed air.
The magazine attachment can be lubricated
around the area of the carriage guide – see fig­
ure [12].
For the purposes of cleaning, the magazine at­
tachment can be dismantled as described be­
low.
Prior to cleaning, remove the collated screws
from the magazine as described in section "Re­
moving collated screws".