Working Instructions; Maintenance Of The Magazine Attach- Ment - Festool DWC 18-2500 Instruction Manual

Inserting collated screw strips

Pull the collated screws [12-3] through the bot-
tom guiding of the attachment, then push the
strip through the second guiding until it engag-
es in the working position.
Pull the belt slightly to make sure that it is safe-
ly fitted.
Make sure that the first screw is in the screwing
axes – see figure [12].

Use the wheel [12-1] to set the required screw-
ing depth.

Turn to the right for inserting the screws deeper,
and to the left to screw to lower depth. The ac-
tual setting position is visible on the presetting
indicator [12-2].
Upon setting, set some screws for testing and use
the wheel [12-1] to adjust the depth, if required.
Each setting change complies with the stop shift o
± 0.1 mm.
 We recommend to screw in automatic mode –
see point b).
12
12-3
– The magazine attachment must not be held in the
depth stop area as there are moving parts!
– Each screw adjustment must be completed. In-
terrupted fastening or releasing of the pressure
during adjustment can result in unsatisfactory
machine function.
– The collated screws and the magazine attach-
ment can only be replaced when the power tool is
16
Removing the collated screws

Pull upwards to remove the belt (figure [13]
or press the transport lever and concurrently
pull the belt downwards (figure [13]
13
12-1
12-2

Working instructions

turned off.
– Never use the magazine attachment in any other
way than specified in this instruction manual.
– Use only original screwing bits.
– Use only original collated screws.
– Always store the collated screws in original
packaging.
– Always work in right angle against the attached
board.
)
).