Table of Contents
Advertisement
BELT AND GUARD REMOVAL
Pulley Guard Removal
. . . WARNING:
Engine should be
.... funning only when pulley guard is
secured in place.
1. Remove hood. Pullout retaining clip
{A} and tilt driven pulley guard to-
ward front of vehicle.
2. Pull out retaining clip (B) to disen-
gage pin {C} from bracket.
3. Move pulley guard toward front of
vehicle to disengage front attaching
device from front bracket.
Drive Belt Removal
. . . WARNING: Never start or run
.... engine without the drive belt in-
stalled. Running an unloaded engine is
dangerous.
Remove
hood
and' pulley
guard.
Remove the two bolts (A) holding disc
brake to the frame. Loosen nut (B) to
separate brake caliper from disc brake
bracket. Pivot the brake bracket as-
sembly half a turn. Open the driven
pulley. Twist and push the sliding half
then hold in open position; slip slack-
ened belt over the top edge of the
sliding half. Slip the belt out from the
drive pulley and remove from vehicle
by passing it under the driven pulley
and disc brake assembly. To install
drive belt follow reverse procedure.
19
Hide quick links:
Advertisement
Table of Contents
