Barrel Installation - Graco PRO Auto Xs Series Instructions-Parts List Manual

Barrel Installation

1. Be sure the gasket (11) and grounding spring (51)
are in place. Make sure the air holes are aligned
properly. Replace if damaged. See F
2. Place the barrel (9) over the power supply (12) and
onto the gun body (32).
3. Tighten the three screws (10, 33) oppositely and
evenly (about a half turn past snug).
CAUTION
Do not over-tighten the screws (10, 33).
Fig. 30. Barrel Installation
309297K
30.
IGURE
11
10
9
4. Assemble the fluid tube (19) into the fluid fitting (23).
Ensure that the ferrules (21, 22) are in place.
Tighten the nut (20).
5. Install and adjust the actuator arm (29) and jam nut
(28). See page 39.
6. Test gun resistance, page 26.
7. Install the gun shroud (2) and air cap, page 34.
8. Install the gun onto the manifold and bracket. See
page 33.
32
12
20
19
29
28
51
TI1569A
33
23
Repair
41