245324 Hc Conversion Kit - Graco PRO Auto Xs Series Instructions-Parts List Manual

Installation

245324 HC Conversion Kit

Part No. 245324 Conversion Kit is available to convert
PRO Auto Xs standard coating guns (Part No. 244589)
to high conductivity guns (244590).
The kit is for use with fluids with low resistivity values.
WARNING
Pressurized Equipment Hazard
To reduce the risk of an injury, follow the
Pressure Relief Procedure on page 17
before installing this kit.
1. Turn the turbine air (TA) off.
2. Flush the gun.
3. Relieve the pressure.
4. Remove the retaining ring (1), air cap (3), and
shroud (2).
5. Refer to the parts drawing for Model 244589 on
page 45. Loosen the two nuts (20) and remove the
fluid tube (19) and ferrules (21, 22). Remove the
other parts (14, 15, 16, 17, 18) at the gun barrel
inlet.
16
6. Slide the loops of the hc tube (19) onto the gun bar-
rel (9).
7. Make sure the barrel threads are clean and dry.
Apply Graco Part No. 116553 dielectric grease to
the fluid fitting (19d) threads and o-rings. Thread
the fitting into the barrel inlet. See F
8. Slide the nut (20) and ferrules (21, 22) onto the
coiled tube (19). Insert the end of the tube into the
fitting (23). Make sure the ferrules seat in the fitting.
Tighten the nut (20).
9
19d
Fig. 10. HC Conversion Kit
10.
IGURE
23
19
22
21
TI1731A
20
309297K