Avaya VSP 7000 Series Installing page 48

Fabric Interconnect connectivity
properly and that the cable connector pull tab is facing up. For more information, see the
following figures.
Warning:
Risk of equipment damage
Incorrect FI cable insertion can cause physical damage to the VSP 7000 Series switch. The
FI cable label can obscure your view of the connection. You must ensure that the FI cable
connector alignment slot and cable connector pull tab is facing up. For more information, see
Figure 1 and Figure 2 in the Example following these procedure steps.
3. For Stack-mode DToR configurations, select a Base unit for the Stack. Use the Base unit
switch to configure one unit as the Base unit.
Important:
Only one unit can operate as the Base unit. Ensure that only one switch is configured as
the Base unit. The switch on all other units must be in the non-base-unit position.
4. Connect AC power.
If you assigned the Base unit and non-base units with the units powered on, you must reset
the Stack for the assignments to apply.
Example
This example shows the correct FI cable an FI port alignment.
Figure 22: Installing Fabric Interconnect cables
Installing Avaya VSP 7000 Series
48
Comments? infodev@avaya.com
August 2014