Operation - EINHELL TE-OS 18/1 Li Operating Instructions Manual

Caution!
For health reasons it is imperative that you
use the dust collection box or a dust extraction
system.
5.3 Fastening the abrasive paper with the
hook-and-loop fastening system (Fig. 4)
•
Only use abrasive paper with the
corresponding dimensions and matching
perforations.
•
Place the abrasive paper onto the oscillating
plate (4) as shown in Fig. 5. Make sure
that the perforations in the abrasive paper
coincide with the oscillating plate.
•
To remove the abrasive paper, simply pull it
off.

6. Operation

6.1 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.2 Battery capacity indicator (Fig. 3/item 6)
Press the battery capacity indicator switch (7).
The battery capacity indicator (6) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
6.3 Switching on and off (Fig. 1/Item 1)
•
To switch on the equipment, move the switch
(1) from "0" to "1".
•
To switch off the equipment, move the switch
(1) from "1" to "0".
TE_OS_18_1_Li_Kit_QVC_USA_SPK7.indb 13 TE_OS_18_1_Li_Kit_QVC_USA_SPK7.indb 13
EN
6.4 Working with the Corner Palm Sander
•
Place the whole surface area of the sanding
disk on the material.
•
Switch on the machine and move it with
gentle pressure over the workpiece, making
circular or transverse and linear movements.
•
Use a coarse grit for coarse sanding and a
finer grit for finish sanding. You can find the
appropriate grit size for the job by carrying out
sanding tests.
Note:
If you use the cordless equipment with our 3.0 Ah
Power-X-Change rechargeable battery, you will
be unable to work with the dust collection box (4)
on account of the size of the battery pack. In this
case please use the dust extraction adapter (2).
(See 5.2.)
Caution!
The dusts which are formed while the equipment
is being used may be a health hazard:
•
Always wear safety goggles and a dust mask
during sanding work.
•
All persons who work with the equipment or
enter the workplace must wear a protective
dust mask.
•
Eating, drinking and smoking are prohibited
at the workplace.
•
Paints containing lead are not allowed to be
used!
- 13 -
17.06.2019 10:17:36 17.06.2019 10:17:36