Operation - EINHELL TP-BS 18/457 Li BL Operating Instructions Manual

5.1.2 Fitting the dust collection box (Fig. 3/
Item 7)
Slide the dust collection box (7) onto the
connection for the dust extraction box (6). To
remove the dust collection box, proceed in
reverse order.
The dust is transferred straight from the sanding
belt into the dust collection box.
To empty the dust collection box (7), open it with
the clip (13). The top part of the dust collection
box (7) can now be removed. Then clean the dust
collection box (7) thoroughly and place the top
part back in position. As you do so, make sure
that the top part is fully inserted all around and
that the clip (13) is locked into position.
The dust collection box (7) can now be refi tted.
Important!
For health reasons it is imperative that you use
the dust collection box or a dust extraction system
via the dust extractor adapter!
5.2 Changing the sanding belt (Fig. 5-6/Item
12)
•
Pull the clamping lever (9) outwards in order
to release the tension from the sanding belt.
•
Pull the worn sanding belt off the drive rollers
(11).
•
Push the new sanding belt onto the drive
rollers.
•
Make sure that the running direction of the
sanding belt (see arrow on the inside of the
sanding belt) is the same as the running
direction of the cordless belt sander.
•
Press the clamping lever (9) to the rear in
order to tension the sanding belt.
5.3 Adjusting belt tracking (Fig. 7/Item 10)
•
Hold the cordless belt sander so that the
sanding plate is at the top.
•
Switch on the cordless belt sander.
•
Turn the belt tracking knob (10) to adjust the
belt running position such that the sanding
belt runs centrally on the two drive rollers.
Anl_TP_BS_18_457_Li_BL_SPK7_USA.indb 12 Anl_TP_BS_18_457_Li_BL_SPK7_USA.indb 12
EN

6. Operation

6.1 Switching On/Off (Fig. 8)
To switch on:
Press the On/Off switch (5).
Continuous operation:
Secure the On/Off switch (5) with the locking
button (4).
To switch off :
Press the On/Off switch (5) briefl y.
The machine can be operated on a temporary or
permanent setting.
6.2 Setting the belt speed (Fig. 9/Item 3)
You can select the belt speed by turning the
electronic speed control dial (3).
PLUS direction:
Increase belt speed.
MINUS direction:
Reduce belt speed.
6.3 Stationary use (Fig. 10-11)
You can use the cordless belt sander in stationary
mode.
To do so, use two screw clamps to fasten the
cordless belt sander on a strong and level
worktop or similar. The two fastening points (14)
must be used for this purpose.
6.4 Instructions for use
Warning! The workpiece you want to sand must
never be held in your hand. Secure the workpiece
on a sturdy surface or with a vise.
•
Allow the cordless belt sander to start running
before you place it on the workpiece.
•
Do not switch off the cordless belt sander
while it is still touching the workpiece.
•
Always hold the cordless belt sander with
both hands while it is running.
•
Always sand wooden workpieces in the
direction of the grain.
6.5 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
- 12 -
20.06.2023 10:17:40 20.06.2023 10:17:40