Lamp Replacement - Toshiba TLP-261 Owner's Manual

Lamp replacement

The lamp will eventually begin to project dark
or dull pictures and finally will not light up.
(Lamp's life depends on operating
conditions.) In such a case, replace the lamp
with new one.
CAUTION
• If you use the projector mounted on the ceiling,
ask the dealer to carry out the maintenance
such as cleaning or replacement of the lamp.
• When replacing, always use lamp "TLPL55"
(sold separately). For details, refer to the lamp
instruction.
• If you have been using the projector, the lamp
will be very hot, and may cause burn injuries.
Wait for the lamp to cool (for longer than 1
hour) before replacing it.
• If the lamp should break, please handle with
care to avoid injury due to broken pieces and
contact your dealer for repair service.
1
Unplug the power cord.
2
Wait until the lamp gets cool enough.
3
4
1
3
2
Take off the lamp cover on the
1
bottom panel.
2
Loosen the two screws, and pull off the
3
lamp cover.
Lamp cover
Pull out the lamp.
Loosen the two fixing screws, and lift up the
handle to pull out the lamp.
65
CONTENTS
Continued