Lamp Replacement - Toshiba TLP-B2U Owner's Manual

Lamp replacement

The lamp will eventually begin to project
dark or dull pictures and finally will not light
up. (Lamp's life length depends on the use
condition.) In such a case, replace the lamp
with new one.
CAUTION
• If you use the projector mounted on the
ceiling, ask the dealer to carry out the
maintenance such as cleaning or
replacement of the lamp.
• When replacing, always use lamp "TLPLB2"
(sold separately). For detail, refer to the
lamp instruction.
• If you have been using the projector, the
lamp will be very hot, and may cause burn
injuries. Wait for the lamp to cool (for longer
than 1 hour) before replacing it.
• If the lamp should break, please handle
with care to avoid injury due to broken
pieces and contact your dealer for repair
service.
1
Unplug the power cord.
2
Wait until the lamp gets cold enough.
3
1
2
4
1
2
Take off the lamp cover on the
bottom panel.
Loosen two screws, and pull off the lamp
cover.
Pull out the lamp.
Loosen the two fixing screws, and lift up the
handle to pull out the lamp.
CONTENTS
57
Continued