Programming Channels Into The Tv's Channel Memory; Programming Channels Automatically - Toshiba TheaterWide 46HM95 Owner's Manual

Programming channels into the TV's channel memory

When you press CHANNEL y or z on the remote control or
TV front panel, your TV will stop only on the channels stored
in the TV's channel memory.
Follow the steps below to program channels into the TV's
channel memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area
and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels.
Note:
• You must configure the antenna input sources before
programming channels (see page 41).
• If the input signal type is set to CABLE for an antenna input, the
automatic channel programming process erases channels that
were previously programmed into the TV's memory.
• If the input signal type is set to ANTENNA, the automatic
channel programming process does NOT erase channels that
were previously programmed into the TV's memory, but adds
newly found channels to the existing set of programmed
channels. To remove a channel from the memory, you must
manually delete it (see next page).
• To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
• Programming channels for an antenna input configured for
CABLE will take substantially longer than for an antenna input
configured for ANTENNA. This is normal; however, once
channel programming is completed, you should not have to
repeat the programming process again unless your Cable TV
service lineup changes significantly.
• If you have a CableCARD™ inserted (page 12), channel
programming for ANT 1 is disabled because the CableCARD™
automatically loads the Cable channel list into the TV's channel
memory.
To program channels automatically:
1. Make sure you have configured the antenna input sources.
See page 41 for details.
2. Press MENU and open the Setup menu.
3. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen).
Setup
Installation
Sleep Timer
On/Off Timer
HDMI 1 Audio Auto
HDMI 2 Audio Auto
Slide Show Interval
2 Sec
AVHD Skip Time
15 min
Navigate Select CH RTN
42
HM95_R1_041-43_061505 42
Chapter 6: Setting up your TV
Back EXIT Exit
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
4. Open the Terrestrial menu, highlight Channel Program,
and press ENTER.
5. Highlight ANT 1 or
ANT 2, depending on
Terrestrial
which antenna input
Input Configuration
you want to program
Channel Program
Channel Add/Delete
channels for, and then
Signal Meter
press ENTER to start
automatic channel
programming.
The TV will automatically cycle through all the channels
for the antenna input you selected, and store all active
channels in the channel memory. While the TV is cycling
through the channels, the message "Scanning channels,
please wait" appears (as shown above).
6. To cancel channel programming, either press EXIT or
highlight Abort in the on-screen display and press ENTER.
When channel programming is done, press CHANNEL
y or z to view the programmed channels.
Channel
Numbers
CHANNEL yz
TV front touchpad
CHANNEL z / y
6/24/05, 9:40 PM
Navigate Back Exit
Select CH RTN EXIT
ANT 1 Antenna
Scanning channels, please wait ...
52%
Abort
MENU
(ENTER)