Connecting A Dvd Player With S-Video, A Vcr, And A Cable Box - Toshiba TheaterWide 46HM95 Owner's Manual

Connecting a DVD player with S-video, a VCR, and a Cable box

You will need:
one signal splitter
five coaxial cables
two sets of standard A/V cables
Note: If you have a mono VCR, connect L/MONO on the TV
(VIDEO 1) to your VCR's audio out terminal using the white
audio cable only.
one S-video cable
one pair of standard audio cables
Note:
• If your DVD player does not have S-video, use a standard
video cable instead. Do not connect an S-video cable and a
standard video cable to VIDEO 1 (or VIDEO 2) at the same
time or the picture performance will be unacceptable.
• If your DVD player has component video, see page 17.
• Do not connect the DVD player and VCR to the same set of
A/V inputs on the TV. (See the illustration, which shows the
VCR connected to VIDEO 1 on the TV, and the DVD player
connected to VIDEO 2.)
To view basic channels and access the TV's features:
Select the ANT 1 video input source.* Use the TV
controls to change channels and access the TV's features.
To view premium Cable channels:
Turn OFF the VCR. Select the ANT 2 video input
source on the TV.* Tune the TV to channel 3 or 4
(whichever channel the Cable box output is set to).
Use the Cable box controls to change channels.
Note: When you use a Cable box, you may not be able to
use the remote control to program or access certain
features on the TV.
To view the DVD player:
Turn ON the DVD player. Select the VIDEO 2 video
input source on the TV.*
To view the VCR:
Turn ON the VCR. Select the VIDEO 1 video input
source on the TV.*
_____________
*
To select the video input source, press INPUT on the remote control
(see page 67). To program the TV remote control to operate other
devices, see Chapter 3.
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs, and other materials is
prohibited under the Copyright Laws of the United States and other
countries, and may subject you to civil and criminal liability.
16
HM95_R1_012-25_061505 16
Chapter 2: Connecting your TV
TV
DVD player with S-video
Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1,
ANT 2, VIDEO 1, VIDEO 2, and VIDEO 3 terminals when the appropriate input
mode is selected.
To enable the TV Guide On Screen
your cable box and to use the TV Guide On Screen
recording features:
1. Connect the G-LINK
page 25.
2. Make sure the VCR is connected to the A/V OUT terminals
on the TV (see illustration).
3. Set the VCR to the appropriate line input (refer to your VCR
owner's manual for details), and then turn OFF the VCR.
4. See Chapter 5 for details on setting up the TV Guide
On Screen
5. See Chapter 7 for details on using the TV Guide On Screen
system.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
From antenna or Cable TV
Cable box Signal splitter
IN OUT
CH 3
OUT
CH 4 OUT
Stereo VCR
VIDEO
IN from ANT
CH 3
CH 4
OUT to TV
OUT
S-VIDEO VIDEO
OUT OUT
® system to work with
® cable according to the instructions on
®
system.
6/24/05, 9:12 PM
IN
AUDIO
L R
IN
OUT
L R
AUDIO
OUT
L
R
®
®