Programming Channels Into The Tv's Channel Memory; Programming Channels Automatically - Toshiba TheaterWide 62HM15 Owner's Manual

Programming channels into the TV's channel memory

When you press CHANNEL y or z on the remote control or
TV front panel, your TV will stop only on the channels stored
in the TV's channel memory.
Follow the steps below to program channels into the TV's
channel memory.

Programming channels automatically

Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels.
Note:
• You must configure the antenna input sources before
programming channels (see page 40).
• The automatic channel programming process does NOT erase
channels that were previously programmed into the TV's
memory, but adds newly found channels to the existing set of
programmed channels. To remove a channel from the memory,
you must manually delete it (see next page).
• To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
• Programming channels for an antenna input configured for
CABLE will take substantially longer than for an antenna input
configured for ANTENNA. This is normal; however, once
channel programming is completed, you should not have to
repeat the programming process again unless your Cable TV
service lineup changes significantly.
• If you have a CableCARD™ inserted (page 12), channel
programming for ANT 1 is disabled because the CableCARD™
automatically loads the Cable channel list in the TV's channel
memory.
To program channels automatically:
1. Make sure you have configured the antenna input sources.
See page 40 for details.
2. Press MENU and open the SETUP menu.
3. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen.
#01E040-043_62HM15 41
Black
62HM15
Chapter 6: Setting up your TV
4. Open the TERRESTRIAL menu, highlight CHANNEL
PROGRAM, and press ENTER.
5. Highlight ANT 1 or ANT 2, depending on which antenna
input you want to program channels for, and then press
ENTER to start automatic channel programming.
Terrestrial
Input Configuration
Channel program
Channel Add/Delete
Signal Meter
Navigate
The TV will automatically cycle through all the channels
for the antenna input you selected, and store all active
channels in the channel memory. While the TV is cycling
through the channels, the message "Scanning channels,
please wait" appears (as shown above right).
To cancel channel programming, either press EXIT or
highlight ABORT in the on-screen display and press
ENTER.
6. When channel programming is done, press
CHANNEL y or z to view the programmed channels.
ACTION
MENU
CHANNEL y
TV front touchpad
TV/VIDEO
CHANNEL z / y
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
ANT 1 Antenna
Scanning channels,please wait ...
DVD RTN
Select Back Exit
CH RTN EXIT
(Continued on next page)
Channel
Numbers
+10
–
100
ENTER
z
EXIT CHANNEL VOLUME MENU
MENU
(ENTER)
5/24/05, 6:18 PM
39%
Abort
POWER
41