Connecting A Digital Audio System; Connecting An Analog Audio System - Toshiba TheaterWide 46HM95 Owner's Manual

Connecting a digital audio system

The TV's DIGITAL AUDIO OUT terminal outputs a Dolby*
Digital or 2-channel down-mixed PCM (pulse-code
modulation) signal for use with an external Dolby Digital
decoder or other external audio system with optical audio input.
You will need:
one optical audio cable (Use an optical audio cable that has
the larger "TOSlink" connector and not the smaller
"mini-optical" connector.)
To control the audio:
Turn on the TV and the digital audio device.
Press MENU on the TV's
remote control and open
the AUDIO menu.
Highlight Audio Setup and
press ENTER.
In the Optical Output Format field, select either Dolby Digital
or PCM, depending on your device (see "Selecting the optical
audio output format" on page 86).
Audio Setup
MTS
Language
Speakers
Optical Output Format
Turn off the TV's built-in speakers in the same Audio Setup
menu (above). Also see "Turning off the built-in speakers" on
page 86.

Connecting an analog audio system

This connection allows you to use external speakers with an
external audio amplifier to adjust the sound level.
You will need:
one pair of standard audio cables
To control the audio:
Turn on the TV and the stereo amplifier.
Turn off the TV's built-in speakers (see "Turning off the built-in
speakers" on page 86).
Note: To hear sound when using an external audio amplifier,
the volume of both the TV and the amplifier must be set to a
reasonable listening level.
20
HM95_R1_012-25_061505 20
Chapter 2: Connecting your TV
Audio
Audio Settings
Advanced Audio Settings
Audio Setup
Stereo
English
On
Dolby Digital
Reset Done
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Dolby Digital decoder or
other digital audio system
Optical
LINE IN
Audio IN
L R
TV
Note:
• Some audio systems may not be compatible with Dolby Digital bitstream
signals. Older audio systems that are not compatible with standard
optical out signals may not work properly, creating a high noise level
that may damage speakers or headphones. THIS DAMAGE IS NOT
COVERED BY YOUR WARRANTY.
• The DIGITAL AUDIO OUT terminal outputs signals only when receiving
digital broadcasts with the TV in single-window mode.
• The DIGITAL AUDIO OUT terminal may not output some digital audio
sources because of copy restrictions.
___________
* Manufactured under license from Dolby Laboratories. "Dolby" and
the double-D symbol are trademarks of Dolby Laboratories.
Analog audio amplifier
LINE IN
L R
TV
OUT
6/24/05, 9:12 PM