Table of Contents
Advertisement
3 Powering Up the 5345/5445
Microstep Indexer/Drive
This chapter explains how to power up the 5345/5445 after
In this Chapter
installation. Topics are:
_
Testing the installation
_
Troubleshooting
_
Repairing or replacing the 5345/5445
3.1 Testing the Installation
Perform the following test procedure to verify that the 5345/5445
Backgroun d
is installed properly, and that it was not damaged internally
during shipment.
The installation test power-up procedure requires a motor and
Configuration
computer or terminal to test the basic functionality of the
5345/5445. A computer or terminal is required for complete
testing.
First, connect the computer or terminal by referring to Chapter 1
Procedure
in the Programming Manual, "Setting up for Programming" (use
the "Terminal Emulator" Mode for this test). Test your
installation as follows:
Perform this initial power-up with the motor shaft disconnected
from the load. Improper wiring or undiscovered shipping
damage could result in undesired motor motion. Be prepared to
remove power if excessive motion occurs.
Rev F
5345/5445 Installation and Hardware Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
WARNING
3 - 1
Advertisement
Table of Contents
