G04 - Dwell; Table 4-3. G04 Dwell Examples - Hurco WINMAX Programming Manual

G04 - Dwell

G04 programs a pause in part program execution.
Modal—No
Format
G04 P ____ or X ____ or U ____
X and U can include a decimal point. For example, X10 is X10.0.
P cannot include a decimal point, and the value is divided by 1000 or
10000. For example, P3000 is 3.0 seconds.
If Active G Code
G93 Inverse Time Feedrate
Refer to G93 - Inverse Time Feedrate, on
page 4 - 89 for information about G93.
G94 Feed Per Minute
Refer to G94 - Feed per Minute (default),
on page 4 - 90 for information about
G94.
G95 Feed Per Revolution
Refer to G95 - Feed per Revolution, on
page 4 - 90 for information about G95.
Table 4–3. G04 Dwell Examples
4 - 12 ISNC G Codes
Then P, X, or U in the G04 Block
Programs
The actual feedrate is the distance divided by
the time.
The number of seconds to dwell.
For example, the block G04 X2.1 pauses for
2.1 seconds before it executes the next block
of code.
The number of spindle revolutions to dwell.
For example, the block G04 X10 pauses for 10
spindle revolutions before it executes the next
block of code.
704-0115-307
WinMax Lathe NC Programming